Blog

Yeastar P560 Installation Guide

Welcome to the installation guide for the Yeastar P560, an advanced telephony module designed to enhance your communication infrastructure. Follow these step-by-step instructions to ensure a smooth and effective installation.

Yeastar P560 Installation Guide

Key Features of Yeastar P560

  • Supports 1 Expansion Board (EX08 or EX30)
  • Allows up to 4 Telephony Modules
  • Accommodates 1 D30 Module
  • Optional telephony modules: S2, O2, B2, SO, GSM, 3G, 4G LTE

Pre-Installation Checklist

  • Ensure the module is clean and intact.
  • Prepare the necessary tools for installation.

Installation Process

Step 1: Preparing the Device

  • Loosen the screws at the bottom of the device.
  • Carefully remove the upper cover.

Step 2: Installing the Expansion Board

  • Push out the empty board from the inside.
  • Insert the Expansion Board (EX08 or EX30).
  • Secure the board by tightening the screws.

Step 3: Inserting Telephony Modules

  • For the EX08 Board, insert the Telephony Modules into the provided slots.
  • Note: Skip this for the EX30 Board.

Step 4: Installing SIM Cards (If Applicable)

  • For GSM/3G/4G LTE modules, insert the SIM card as instructed.
  • Note: Skip this if these modules are not included.

Step 5: Closing the Device

  • Replace the cover and secure it with screws.
  • For GSM/3G/4G LTE modules, attach the antenna to the socket.

Step 6: Installing DSP Module

  • Open the device cover and insert the DSP module (D30) at a tilt angle.
  • Press down and secure it with screws.

Desktop Installation

CAUTION: Ensure proper air circulation and stability.

  • Keep a 5~10cm gap around the device.
  • Avoid placing heavy objects on the device.
  • Attach the supplied rubber feet to the bottom corners.

Rack Installation

CAUTION: Use only the provided mounting kit.

  • Attach the brackets to the PBX.
  • Secure the PBX in the 19-inch rack using the rack’s mounting equipment.

Ground Connection

CAUTION: Proper grounding is crucial for safety and device protection.

  • Insert the screw stud into the Grounding port.
  • Connect an 18AWG grounding wire.
  • Secure the wire with the screw nut and attach it to the grounding terminal.

This guide provides a comprehensive overview for installing the Yeastar P560. For detailed instructions or support, please refer to the Yeastar P560 manual or contact our technical support team.

Also Check

Yeastar P560 VoIP PBX (Private Branch Exchange) phone system

A Comprehensive Review of the Yeastar P560 VoIP IP PBX Phone System

Steps on Connecting Epson Printer with the Wi-Fi Network